Do smart homes save electricity?
A smart home does not make your appliances use less power while they run. What it does is stop them running when nobody needs them: lights and ACs that go off on a schedule or when you leave, and a water heater that is on only when someone will use the hot water.
How much that adds up to depends on your house and habits, so we do not promise a figure.
Where the waste comes from
Electricity at home tends to be wasted in a few familiar ways: lights burning in rooms nobody is using, an AC cooling an empty bedroom, a water heater kept on all day for one morning bath, and a pump that keeps running after the tank is full. A smart home works on exactly those habits. It does not change how much power an appliance draws; it changes how long the appliance is on.
Lights that go off without being told
- Schedules. Outside lights can come on in the evening and go off at a set hour, every day, without anyone remembering.
- Motion sensors. In a corridor, store or toilet, the light comes on when someone walks in and goes off again once the space is empty.
- A leaving scene. One tap on your way out turns off every light you chose, instead of a walk round the house.
See smart lighting for what we fit.
ACs that are not left running
AC control is for ACs that come with a remote, and it lets you treat the AC like a light: on a schedule, in a scene or from your phone. The AC in the children's room can go off at 3 am after the room has cooled; every AC in the house can go off with the leaving scene; and if you are not sure you switched one off before travelling, you can check and turn it off from your phone, provided the house has internet.
More on AC and water heater control.
A water heater that is on only when needed
A water heater left on all day keeps reheating water that nobody uses. With a smart switch on the heater, it can come on shortly before the household bathes and go off afterwards, on a schedule set up with you. On days when the routine changes, you switch it on from your phone instead.
A pump that stops when the tank is full
Water tank automation starts the pump when the tank runs low and stops it when the tank is full, so the pump does not run on with water spilling over the top. It needs the pump and the tank to be in good working order already. See water tank automation.
Do smart devices use power themselves?
Yes, a little. Each switch, socket, sensor and the hub needs a small, steady supply to stay connected and ready for your next command. That is small next to what an AC or a water heater uses when it runs, which is why switching those off at the right times is where a smart home makes its difference.
On an inverter or solar, less waste means stored power stretches further through the night. For backup systems, see ZuraLink Power.
Questions and answers
Does a smart home use more electricity?
The devices draw a little to stay connected. Against that, lights, ACs and the heater go off when nobody needs them, so the overall effect depends on how you use the house.
Will a smart home reduce my electricity bill?
It can cut waste, and that shows on the bill or in how long your inverter lasts. How much depends on your home and habits, so we do not quote a saving.
Where should I start if I want to waste less power?
Start with what draws the most and gets left on: the ACs and the water heater. Then add motion sensors where lights are often forgotten. The home builder shows the price of each.
Can I switch off my AC from my phone when I am away?
Yes, if the house has internet. Without it, the AC still follows any schedule you saved.
Where to go next
- Home builderAny mix of devices, priced as you go
- One room smart home₦330,000 installed
- Apartment smart home₦1,035,000 installed
- Smart homes and power cutsGuide
- Smart home cost room by roomGuide
- All guidesStraight answers about smart homes
- Smart home cost in NigeriaInstalled prices